Needle type printer ribbon fault

1, the ribbon breaking

Ribbon tension is too large, broken suture or hammer broken Ribbon Ribbon fracturecause. The former case can be fractured parts of cut, sewn back; after a situation as long as the replacement of the ribbon can be.

2, the ribbon is card

The edges of the ribbon take off silk, pilling after easily entangled ribbon round, cause the ribbon round by the card, ribbon cannot retract the ribbon box normal. The solution is: first open the printer cover, the ribbon rotary arm and hammer rows ofinterlocking handle to open, in the ribbon cartridge feed end of the ribbon gently back,and then close the Nylon ribbon roll rotating arm and hammer rows of interlocking handle, turn on the power, the machine in self-test ribbon will be put back into the ribbon box.

3, the Holzer effect is damaged

Ribbon cassette frequently, Holzer effect device is continuously pressed, causing thedamage fracture. This failure can only be replaced epson printer ribbon transfer arm assembly orreplaced by a ribbon motion sensor.

4, the thermal transfer printer ribbon drive wheel drive belt is worn or broken

This failure is due to drive belt caused by use of time is too long or character chainfriction. The solution is to adjust the character chain position, making it no longer afriction drive belt; broken, please replace the.

5, ribbon motion sensing signal interrupt

Check Ribbon motion sensor signal line is damaged, replace if fault signal line; and then check the interlock ribbon motion sensing signal line socket at the J6 conversionboard is damaged or contact is not good, please replace or insert signal line.